A humming noise can indicate poor freezer performance but not compressor problems. To check whether the compressor is the culprit, simply unplug the freezer, then plug it back in again. Hopefully, the freezer will start working again. If the humming continues, it is a good idea to seek additional assistance. Here are some possible solutions. Hopefully one of these will fix your freezer issue. Otherwise, follow these steps to troubleshoot the freezer.
Condenser fan motor
There are several reasons your freezer may not be getting cold enough, and the evaporator fan motor is a common culprit. When the freezer door is opened, the evaporator fan motor will automatically turn off, and this could be a sign of a damaged condenser fan motor. To diagnose the cause of this problem, open the freezer door and try to turn the switch to the freezer’s cold setting. If you still have problems, contact a freezer service technician and have them examine the unit.
Usually, this issue can be easily fixed. First, remove the panel that covers the evaporator. Then, unplug the freezer from the wall and use a coil brush to clean the condenser coil. Next, replace the fan blade. Be sure to replace it with a new one. If the condenser fan is working properly, the freezer will freeze properly.
Electronic display board
If your freezer is running but not freezing, the user control display board may be the culprit. This board displays the internal temperature of your freezer and controls other components including the defrost heater and compressor. If this board is malfunctioning, your freezer may run continuously, but you may have no idea why. In this situation, it’s best to check the thermistor temperature sensor. If it’s defective, you should replace it.
Condenser pump
If your freezer is running but not freezing, it is likely that it’s the condenser pump. The condenser is a part of your refrigerator that circulates the refrigerant throughout the coils. Faulty condensers are not effective at dispersing heat, causing your freezer to perform poorly. Check the condenser fan to see if it’s blowing air.
Another component of your freezer is the compressor, which is responsible for circulating the refrigerant through the coils. A faulty compressor can prevent the freezer from cooling, so check that other parts are functioning properly before replacing the compressor. Check the compressor’s continuity with a multimeter to make sure it’s working properly. If it doesn’t, replace the entire freezer. This step can be very time-consuming and frustrating, but it’s worth it if you want your freezer to run smoothly again.
Checking if freezer is plugged in
The first thing to check before attempting any repairs is whether your freezer is plugged in. Make sure that the freezer is plugged into an outlet that has been verified as working. If you’re unsure of the power source, try plugging in a lamp. If it’s still frozen, call an electrician. Alternatively, if you can’t find any answers after a few hours, try a different outlet and wait 24 hours before attempting repairs.
If the appliance is plugged into a GFCI outlet, make sure that the electrical cord is not damaged. If so, the power source could be damaged, which may cause the refrigerator to malfunction. In this case, you’ll want to call an electrician or repair technician to get it fixed. In addition, you should check the circuit breaker or fuse box to make sure that the outlet is working properly. If there is no power, you may need to replace the electrical cord.
Checking for frost
If you notice water on the floor, there could be a clog in the drain tube. Locate it in the freezer’s floor or beneath the vegetable drawers in the refrigerator compartment. If the clog is too large to remove by hand, try using a turkey baster soaked in bleach water to clean it out. Another option is to push the clog out with a small tubing. Make sure that there’s ample clearance around the freezer. The freezer should also be in an unheated, cool, and not sunny location.
A broken door gasket or door lid may cause frost on the inside. If the defrost timer is broken, it may be causing the frost to build up. The defrost thermostat is responsible for turning on and off the defrost heater at the appropriate intervals. If it isn’t working, the defrost heater will never turn on. If the thermostat is defective, the freezer will not defrost properly, causing frost on the inside.
Checking for a clog in the coils
If you’ve recently noticed that your freezer isn’t freezing, it might be due to a clogged defrost drain. The drain is located on the back wall of your freezer, just above the slope from the floor to the back. This hose is subject to clogs from debris and food particles. If this happens, you’ll notice that the water inside your freezer is leaking out. To remove the ice clog, clean the drain hole with warm water and a long, slender instrument.
If the problem persists, you might need to replace the start relay. This small part is located on the back of the freezer under the terminal cover. You can test this part with a multitester. If the relay terminals are damaged, they won’t read zero. If the relay is good, you can simply clean the condenser coils. Once you’ve cleaned the coils, your chest freezer should once again freeze properly.
Within Cobb County Community Service Area, here are the popular cities we service:
Marietta, Macland, East Cobb, Blackwells, Sandy Plains, Noonday, Westoak, Kennesaw, Smyrna, Cumberland, Powder Springs, Clarkdale Park, Powers Park, Fair Oaks, Mars Hill, Chattahoochee Plantation, Acworth, Lost Mountain, Vinings